PaaS Partner Community

  • November 22, 2013

Debugging Oracle Business Process Management and Events (Oracle EDN) by Jan van Zoggel

Juergen Kress
PaaS Partner Adoption

We are using Oracle EDN events to communicate between Oracle Business Process Management instances and from the Oracle ADF tasks to Oracle Business Process Management. We use the correlation configuration to make sure the events arrive at the correct instances.

We had our share of problems with events during our project and it often took us some time to debug it. Since documentation is scattered across blogs, support sites and some manuals to configure the whole setup. The documentation about debugging your problems is very thin.

1. Check EM logging (duh)
All event steps are logged and the Enterprise Manager ECID (Execution Context ID) can help you detect what is going wrong.
2. Use Oracle Enterprise Manager’s ability to check the Business Events:
right click soa-infra and voila: Business Events! It shows an overview of registered events, amounts, subscriptions and is also the place for recovery of your events,
3. Check your Oracle Business Process Management project project_properties.wsdl file Read the full article here

SOA & BPM Partner Community

For regular information on Oracle SOA Suite become a member in the SOA & BPM Partner Community for registration please visit www.oracle.com/goto/emea/soa (OPN account required) If you need support with your account please contact the Oracle Partner Business Center.

Blog Twitter LinkedIn image[7][2][2][2] Facebook clip_image002[8][4][2][2][2] Wiki Mix Forum

Be the first to comment

Comments ( 0 )
Please enter your name.Please provide a valid email address.Please enter a comment.CAPTCHA challenge response provided was incorrect. Please try again.