Skynet Big Data Demo Using Hexbug Spider Robot, Raspberry Pi, and Java SE Embedded (Part 3)

In Part 2, I described what connections you need to make for this demo using a Hexbug Spider Robot, a Raspberry Pi, and Java SE Embedded for programming. Here are some photos of me doing the soldering. Software engineers should not be afraid of a little soldering work. It's all good.

See:

Skynet Big Data Demo (Part 2)

One thing to watch out for when you open the remote is that there may be some glue covering the contact points. Make sure to use an X-Acto knife or small screwdriver to scrape away any glue or non-conductive material covering each place where you need to solder.

And after you are done with your soldering and you gave the solder enough time to cool, make sure all your connections are marked so that you know which wire goes where. Give each wire a very light tug to make sure it is soldered correctly and is making good contact.

There are lots of videos on the Web to help you if this is your first time soldering. Check out Laday Ada's (from adafruit.com) links on how to solder if you need some additional help: http://www.ladyada.net/learn/soldering/thm.html

If everything looks good, zip everything back up and meet back here for how to connect these wires to your Raspberry Pi. That will be it for the hardware part of this project. See, that wasn't so bad. ;-)

Comments:

Post a Comment:
Comments are closed for this entry.
About

Hinkmond Wong's blog on making Machine to Machine (M2M) and the Incredible Internet of Things (IoT) smarter with Java Embedded Technologies

Search

Archives
« April 2014
SunMonTueWedThuFriSat
  
2
3
4
5
6
7
8
9
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
   
       
Today