X

Developer Partner Community

  • November 22, 2014

Dynamic parameterize model level validation using message token ADF by Ashish Awasthi

Juergen Kress
PaaS & Middleware Partner Adoption

clip_image001This post falls under ADF Basics category (about a little trick in model layer) but about a common development requirement
How can we create dynamic ADF BC validation ? means it takes a parameter at run time and append it to validation message
Read previous post on model level validation-
Conditional Execution of Model (EO) level Validation- Oracle ADF
ViewObject Validation rules for transient attributes (Model level validation in ADF)
In this post I am using Departments table of oracle HRSchema

  • First step is same , prepare model (EO,VO and AM) using Departments table
  • Creating a business rule that DepartmentName can not be duplicate, for this created a alternate key in EntityObject

Read the complete article here.

WebLogic Partner Community

For regular information become a member in the WebLogic Partner Community please visit: http://www.oracle.com/partners/goto/wls-emea ( OPN account required). If you need support with your account please contact the Oracle Partner Business Center.

Blog Twitter LinkedIn Mix Forum Wiki

Be the first to comment

Comments ( 0 )
Please enter your name.Please provide a valid email address.Please enter a comment.CAPTCHA challenge response provided was incorrect. Please try again.